Solution for **Disabling Arming** When the Arm Switch is in an Unsafe Position
3/5/25Less than 1 minute
When arming a drone, the message "ARMSWITCH" is displayed. This usually means that the flight controller has detected the arm switch in an unsafe position (armed position). Below are troubleshooting and resolution steps:
Setup Steps:
- Open Betaflight Configurator or the SpeedyBee App and connect to the flight controller.
- Locate the ARM Mode, and check if it is activated. If it is activated, use the corresponding switch on your remote controller to turn it off (the specific switch depends on your custom settings).
